Aug 27, 2014

I bought a 3d printer

That's right. It's not a very fancy one. In fact it's a reasonably priced makerbot replicator dual clone, known as the fastforge creator.

Jul 21, 2014

New ledRing controller


Some of you may have seen a project I wrote about on instructables. http://www.instructables.com/id/Rainbow-Ring-Wall-Clock/

Well there were a few problems I faced with it:
  • Underpowered micro-controller
  • Incorrect mixing of resin
  • Broken led after resin had set 
 (I do intend to do a failure analysis on that LED at some point. When I get the time)

So it was definitely time to do a second revision.